Recent content by Helipilot

Maybe look under the seat and verify everything electrical is plugged in and seated correctly…no pun intended.

I bought an eliminator off Amazon last year that just plugs in at the fuse panel. Super easy install, and has worked flawlessly for 17,000 miles. The Amazon link posted above is the one I purchased.

Thanks for posting this thread. I know it took me a while, but I was determined to do this project. What a nice touch.

For those curious what the actual difference is.

Today is the day.

I took a few hours to grind and polish. Then I dropped it off for the Powder Coating. I’ll install it this week.

Detailing in HPR to match my HPR Raptor.

Just picked it up from powder coating. On to the next step.

I was only going to grind off a few today. Then I realized how much aluminum dust I had all over me, so I said F-It, get-er-done.

Finally, just over a year since seeing this post, I’ve gotten around to starting this project. Found a used cover online. Spent today getting rid of the casting markers.

That sounds like a loose skid plate. Did you have a recent oil change?

Mine.

My other vehicle is the Hummer EV. I rotate between the Braptor and the EV. Commuting the Braptor does not get tiresome, even after a year. And daily life with the Hummer is just easy. I do enjoy going between the two vehicles. I recommend the EV as a second choice!!

All from memory as mine are currently installed and difficult to access due to a Tuffy Storage Trunk being installed, I believe they are the same size as all the bolts used for the hardware on the roll bar. Here’s another pic I found of some of the parts you need installed on a Bronco.

Looks very familiar. Congrats.