WTB - Bronco Raptor Flare Deletes w/ or w/o modified liners

[ChiliPepper]

Something that looks like this for trail use only.

• No mud flaps
• No drill - bolt on to existing OEM quarter panels
• With modified (shortened) liner preferred
• Blends into rear passenger door trim

Yes, I've seen the ADV fiberglass kit. I think the 4.5" w/ 1" lift is still too wide. I would like something more flush to the quarter panel.

Let's go 3rd party aftermarket folks, starting making BR specific products. Show us some products, please. Everything I see says, "21-23 Bronco excluding Raptor".
@FordProducts
@IAG
@AndersonComposites
@DV8offroad
@RoughCountry
@BodyGuardBumpers
@HavocOffroad
@HookeRoad
@Bushwacker
@BlackRhino

 

[JohnGalt]

I like this general design concept.

But if someone were to make them I’d prefer a finish that matched the hood heat extractor/ mirrors, door handles but I’m sure others would want them sandable/paintable.

Liners would be pretty much a requirement for me. It’d be nice if they had smoother contours than the OEM. I really like the OEM liners except they trap mud in a number of places that are hard to see and clean.

I’d prioritize cost over bullet proof design and manufacture. I certainly won’t want to drop almost $4k for ADV with liners, then have to paint them and then ppf them and worry about dinging them.

I’d buy reasonably priced, black plastic flares that will look “okay” after taking a ding and some scratches. But everyone’s use case is different.

 

[JohnGalt]

Now I remember why I gave up hope on a solution for the aftermarket flares….

Easier just to design new quarters…