Foutz slot delete kit

Turbo yzel

Active member
Oct 9, 2023
73
Gallery
92
155
DMV
Current Ride
2022 Braptor
Last week I was able to get part of this installed
I still need to get them welded on
Just wanted to make sure I had them in right spot
Here are some photos for others to use and some tips 👍
 

Attachments

  • IMG_3607.jpeg
    IMG_3607.jpeg
    149.3 KB · Views: 15
  • IMG_3605.jpeg
    IMG_3605.jpeg
    127.7 KB · Views: 15
  • IMG_3606.jpeg
    IMG_3606.jpeg
    99.5 KB · Views: 15
OP
Turbo yzel

Turbo yzel

Active member
Oct 9, 2023
73
Gallery
92
155
DMV
Current Ride
2022 Braptor
  • Thread Starter
  • Thread starter
  • #2
Here are some more
I had to loosen one side of the sway bar at a time to get factory bolts out
As you can see it would hit when sliding out
So I swapped the ones in back 180 and put them in reverse
So if I need to do work on the trail it will be a little easier to get to without messing with the sway at again
 

Attachments

  • IMG_3610.jpeg
    IMG_3610.jpeg
    147.3 KB · Views: 8
  • IMG_3608.jpeg
    IMG_3608.jpeg
    165.8 KB · Views: 8
Last edited:
OP
Turbo yzel

Turbo yzel

Active member
Oct 9, 2023
73
Gallery
92
155
DMV
Current Ride
2022 Braptor
  • Thread Starter
  • Thread starter
  • #3
Also make sure that you put ones with notch cut out in right spot 👍
 

Attachments

  • IMG_3609.jpeg
    IMG_3609.jpeg
    133.3 KB · Views: 9
OP
Turbo yzel

Turbo yzel

Active member
Oct 9, 2023
73
Gallery
92
155
DMV
Current Ride
2022 Braptor
  • Thread Starter
  • Thread starter
  • #4
And finally I tried again for the 3rd time to adjust my positive camber after installing plates
However I am now almost out of adjustment after doing “out of the box” 1st time
Then 1 full turn after billet rack install
And this time 2-1/2 turns with slot delete kit
And I still have a little positive camber

Strangely it still says same amount after each time I adjusted the upper arms 🤷‍♂️
At least it seems to drive a little better after the last 2-1/2 turn session
 

Attachments

  • IMG_3612.jpeg
    IMG_3612.jpeg
    162.7 KB · Views: 11
  • IMG_3611.jpeg
    IMG_3611.jpeg
    164.1 KB · Views: 11

Top Member Reactions

Top