Ford Performance Air/Oil Separator DIY installation

[Splaktar]

I am taking my Bronco Raptor into the dealer tomorrow for an oil change and to look at an issue where the front camera spray nozzle leaks my entire tank of wiper fluid after installing my winch. While I'm there, I will inquire again about an update for the FP AOS fix. My dealer has not contacted me with any information about it since I initially requested it. They have just said that FP is not responding to them so far. I don't expect that to change.

I haven't had them do the zip tie fix yet. I tried to do it myself, but I couldn't figure out exactly where to tie it and how to mount myself over the engine up that high to properly leverage it. So I will ask them to either do this or whatever the current workaround is that FP recommends.

What's the status of everyone else in this boat?

• Did you have the FP AOS uninstalled?
• Did you get the zip tie fix (how's it working?)?
• Or have you just let it keep rubbing?

 

[Shelby392R]

I am taking my Bronco Raptor into the dealer tomorrow for an oil change and to look at an issue where the front camera spray nozzle leaks my entire tank of wiper fluid after installing my winch. While I'm there, I will inquire again about an update for the FP AOS fix. My dealer has not contacted me with any information about it since I initially requested it. They have just said that FP is not responding to them so far. I don't expect that to change.

I haven't had them do the zip tie fix yet. I tried to do it myself, but I couldn't figure out exactly where to tie it and how to mount myself over the engine up that high to properly leverage it. So I will ask them to either do this or whatever the current workaround is that FP recommends.

What's the status of everyone else in this boat?

• Did you have the FP AOS uninstalled?
• Did you get the zip tie fix (how's it working?)?
• Or have you just let it keep rubbing?

it is not too difficult. pull the canistar up off the metal bracket push to the drivers side like an inch just passed the hose it hits on the botton and just zip tie it there. holding it towards drivers side. Yes and still no fix. Ford already reimburded me full amount but still no fix but when they do should get everything free to fix it.